Switch and Charge Jack
Original price was: $8.50.$7.05Current price is: $7.05.
Switch and Charge jack: Are you tired of removing your robot’s armor after every match just so you can charge the batteries? This lightweight jack makes charging batteries as easy as plugging in a connector. Robots that draw less than 6A continuous can even use this as the main power switch!
Switch and Charge Jack shown here, wired into our red and black mini terminal blocks.
Make your life easy– no more unbuttoning your bot to disconnect the battery! Use our charge jack. Once the jack is plugged in, the power is cut to the bot, and it’s safe. You can then charge your battery, all without taking the battery out. It’s so easy, at a very low cost.
Used on all of our Viper Kits.
Back to shopping page: https://itgresa.com/robot-shop/
Original price was: $8.50.$7.05Current price is: $7.05.
143 in stock (can be backordered)
Product Documents
CAD Files - IGS
Specifications
Switch and Charge and Jack, found on our Viper Kits:
Rated Current: 1A forever, 6A for 5min, 15A burst
Jack Dimensions: 13.3 x 11.3 x 7.5mm (0.53 x 0.45 x 0.295in)
Mounting hole: 6mm (0.23″)
Wire length: 10cm (3.94in)
Connector: Female JST on the jack, Male JST on the plug
Jack Weight (with wires and connector): 4g (0.14oz)
For robots that draw >6A, you can still use this connector as a charge jack! In that case, we recommend using our Mini Power Switch between the battery and the robot. (Simply tape off and do no use the “BOT” lead in the below picture.)
